Panasonic PT-EW630U - Manual (Page 20)

About Your Projector
20
- ENGLISH
Preparation
(15)
(23)
(20) *
(22)
(19)
(14)
(18)
(16)
(26)
(17)
(25)
(24)
(21)
(14) <ECO> button
Display the Eco management function.
( Æ page 44)
(15) <P-TIMER> button
Operate the P-timer function. ( Æ page 44)
(16) <FREEZE > button
Pauses the projected image and sound
tentatively. ( Æ page 44)
(17) <KEYSTONE> button
Correct keystone distortion. ( Æ page 45)
(18) <LENS SHIFT> button
Select the Lens Shift function. (
Æ page 44)
(19) <ZOOM +/-> button
Zoom in and out the images. (
Æ page 46)
(20) <P IN P> button
Operate the Picture in Picture function.
( Æ page 46)
* Only for EZ570 series, EW630 series and
EW530 series.
(21) ON/OFF switch
When using the remote control, set this switch to
“ON”. Set it to “OFF” for power saving when it is
not in use.
(22) <SCREEN> button
Select a screen mode. ( Æ page 44)
(23) <D.ZOOM> button
Select the Digital zoom +/- mode and resize the
image. ( Æ page 44)
(24) Input Selection buttons: <INPUT 1>,
<INPUT 2>, <INPUT 3>
Select an input source (Input 1 – Input 3).
(25) <FOCUS +/-> button
Adjust the focus. ( Æ page 46)
(26) <INFO> button
Operate the information function. ( Æ page 46)
(27) Wired remote jack
Connect the M3 stereo mini-jack cable (not
supplied) to this jack when using as a wired
remote control.
Attention
Do not drop the remote control. z
Avoid contact with liquids. z
Do not attempt to modify or disassemble the remote z
control.
Note
The remote control can be used within a distance of z
about 5 m (16.4 ft) if pointed directly at the remote control
signal receiver. The remote control can control at angles
of up to ± 30 ° vertically and ± 30 ° horizontally, but the
effective control range may be reduced.
If there are any obstacles between the remote control z
and the remote control signal receiver, the remote control
may not operate correctly.
You can operate the projector by reflecting the remote z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receiver is lit with a z
fluorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
(27)