Panasonic PT-EW630U - Manual (Page 97)

Replacement
ENGLISH -
97
Maintenance
J
Replacing the Lamp unit
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector. z
Attach the lamp unit and the lamp cover securely. z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the z
lamp, the connector may be damaged.
Turn off the Power by following the 1 )
procedure in “Turning off the projector
(
Æ
page 40). Unplug the AC power cord.
Wait at least 1 hour and make sure the
lamp unit and surroundings are cool.
Use a Phillips screwdriver to loosen 2 )
the lamp cover fixing screw and
remove the lamp cover.
Remove the lamp cover by pulling it slowly z
toward the direction of the arrow.
Use a Phillips screwdriver to loosen 3 )
the three lamp unit fixing screws until
the screws turn freely. Hold the used
lamp unit by its handles, and pull it
gently from the projector.
Insert the new lamp unit in correct 4 )
direction. Tighten the three lamp unit fixing
screws securely with a Phillips screwdriver
Attach the lamp cover, and tighten the lamp 5 )
cover fixing screw securely with a Phillips
screwdriver.
Attach the lamp cover by pushing it slowly z
opposite the direction of the arrow.
Note
When you replace the new lamp unit (ET-LAE200), the projector z
resets the total usage time of the lamp unit automatically.
Lamp unit fixing screws
Handles
Lamp cover
Lamp cover
fixing screw