Panasonic PT-EW630U - Manual (Page 35)

ENGLISH -
35
Getting Started
Connections
Before connecting to the projector
Read carefully the instruction manual for the device to be connected. z
Turn off the power switch of the devices before connecting cables. z
If any connection cable is not supplied with the device, or if no optional cable is available for connection of the z
device, prepare a necessary system connection cable to suit the device.
Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. z
In this case, a time base corrector (TBC) must be connected.
The projector accepts the following signals: VIDEO, S-VIDEO, analogue-RGB (with TTL sync. Level) and z
digital signal.
Some computer models are not compatible with the projector. z
When using long cables to connect with each of equipment to the projector, there is a possibility that the image z
will not be output correctly unless a compensator is used.
For details on what video signals the projector supports, see “List of compatible signals”. ( z Æ page 109 to 113)
Connecting example
Analog Out Signal Table
Input terminal and Input signals Monitor Out
Input 1
RGB
RGB(PC Analog) YES
RGB(Scart) NO
DVI-D
DVI-D NO
DVI-D(HDCP) NO
HDMI HDMI NO
Input 2
G, B ,R, SYNC/HD, VD RGB YES
VIDEO Video NO
Y, P B /C B , P R /C R Y, P b /C b , P r /C r NO
Input 3
Y, P B /C B , P R /C R Y, P b /C b , P r /C r NO
S-VIDEO S-video NO
VIDEO Video NO
Attention
When connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between the projector z
and the video deck.
If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the projector and the z
video deck.
Note
When using an HDMI cable, check that it is compliant with the HDMI standard. Using a cable that is not compliant with the HDMI standard z
may result in problems such as the image cutting out or not appearing.
When connecting the 1 080p signal using HDMI, use a cable compliant with 1 080p signal.
This projector does not support the Viera link (HDMI). z
For the specifications of the RGB signals that can be applied from the PC, refer to “List of compatible signals”. ( z Æ page 109 to 113)
Computer Audio system
Video deck
(TBC built-in) Blue ray disk
player with
HDMI terminal