Panasonic PT-EW630U - Manual (Page 40)

Powering ON/OFF
40
- ENGLISH
Basic Operation
Press the < 1 ) > button on the side control or
the <STANDBY> button on the remote control,
and Power off? appears on the screen.
Press the < 2 ) > button on the side control or
the <POWER ON> button on the remote control
again to turn off the projector. The <ON(G)/
STANDBY(R)> indicator starts to blink orange,
and the cooling fans keep running. At this time,
you can unplug the AC power cord even if the
fans are still running.
When the projector has cooled down enough, the
3 )
<ON(G)/STANDBY(R)> indicator stops blinking
and you can turn on the projecto r.
Note
Do not put the projector in a case before the projector is z
cooled enough.
While the <ON(G)/STANDBY(R)> indicator is blinking, z
the lamp is being cooled down and the projector cannot
be turned on. Wait until the <ON(G)/STANDBY(R)>
indicator stops blinking to turn on the projector again.
The projector can be turned on after the <ON(G)/ z
STANDBY(R)> indicator turns red. The waiting time
to restart will be shortened when the normal power-off
processing for fan cooling is completed, compared with
the time the AC power cord is immediately unplugged
after the power-off.
J
Direct Power Off function
You can disconnect the power cord from the wall
outlet or turn off the breaker even during projection
without pressing the < > button.
Note
When using the Direct Power Off function, you cannot z
restart the projector immediately after the power is
disconnected. The lamp remains high temperature and
needs to be cooled, so it sometimes takes longer time
than usual for the lamp to light up again.
While the cooling fan is operating, do not place the z
projector inside a box or bag.
Note
If the <STANDBY> button on the remote control is z
pressed, the time countdown will be brought to an end
without appearing Power off? afterwards on the screen.
Turning Off the Projector
Power off? disappears after 4 seconds.