Panasonic PT-EW630U - Manual (Page 69)

Setting
ENGLISH -
69
Settings
Execute
J
Press ▲▼ to select one among the 1 )
items as below and then press the
<ENTER> button.
Start It executes the count up or count
down function.* 1
Reset Reset the P-timer values.* 2
Exit To exit the P-timer operation.
Press the <ENTER> button at Start and the *1 :
indication changes into Stop. To stop Count up or
Count down, press the <ENTER> button at Stop
on the screen menu, then the indication changes
into Restart. Press the <ENTER> button at
Restart to resume Count up or Count down.
Press the <ENTER> button at Reset to return to *2 :
the following value:
Count up "000:00"
Count down Timer that you set
Attention
To stop the [P-timer] function, press the <P-TIMER> z
button.
To cancel the [P-timer], press and hold the <P-TIMER> z
button for a few seconds.
Security
This function allows you to use the [Key lock] and [PIN
code lock] function to set the security for the projector
operation.
Press ▲▼ to select [Security]. 1 )
Press ► or the <ENTER> button to 2 )
access the submenu.
Key lock
J
This function locks the side control and remote control
buttons to prevent operation by unauthorized persons.
Press ▲▼ to select the desired items 1 )
as below.
Unlocked.
Lock the operation of the side
control. To unlock, use the remote
control.
Lock the operation of the remote
control. To unlock, use the side
control.
PIN code lock
J
This function prevents the projector from being
operated by unauthorized persons and provides the
following setting options for security.
Press ▲▼ to select the desired items 1 )
as below.
Off Unlocked.
On 1
Enter the PIN code every time
turning on the projector.
On 2
Enter the PIN code to operate
the projector once the power cord
is disconnected; as long as the
AC power cord is connected, the
projector can be operated without
a PIN code.
Attention
Whenever you change the PIN code lock setting or the z
PIN code (the four-digit number), you are required to
enter the PIN code. The "1234" is set as the initial PIN
code at the factory.
PIN code change
J
The PIN code can be changed to your desired four-
digit number.
Press ▲▼ to select [PIN code change] 1 )
and then press <ENTER> button.
Current Pin code dialog box appears. z
Press ▲▼ to enter the current code. 2 )
Press ► button to fix the number and
move the red frame pointer to the next
box.
The New PIN code input dialog box appears. z
Repeat these steps to set a new PIN 3 )
code.
Shutter
Shutter function is available to block out light to the
screen, so that the screen can be used for the other
presenters.
Press ▲▼ to select [Shutter 1 ) * ].
Press ► or the <ENTER> button to 2 )
access the submenu.
* (Only for EZ570 series, EW630 series and EX600
series.)
Protection
J
Prohibit the shutter operation from the remote control
and the projector's side control.