Panasonic PT-DW90XE - Manual (Page 18)

About Your Projector
18
- ENGLISH
Preparation
About Your Projector
Attention
Do not drop the remote control. z
Avoid contact with liquids or moisture. z
Do not attempt to modify or disassemble the remote control. z
Do not let strong light shine onto the signal receptor. The remote control may malfunction under strong light such as z
fluorescent.
Note
The remote control can be used within a distance of about 30 m if pointed directly at the remote control receiver. The z
remote control can control at angles of up to ± 15 °C vertically and ± 30 °C horizontally, but the effective control range may
be reduced.
If there are any obstacles between the remote control and the remote control signal receptor, the remote control may not z
operate correctly.
The signal will be reflected off the screen. The operating range may differ due to the screen material.
When the projector receives a signal from the remote control, the Power indicator will flash. z
Remote control
J
Top view
Front view
J
Installing/removing batteries
Press the tab and
lift up the cover.
Insert the batteries according to
the polarity diagram indicated
inside. (insert the side first).
Remove the batteries in the
reverse order to setting.
Bottom view
J
Remote control wired terminal
( Æ page 21)
Remote control signal emitters
Specifies the ID of the remote control.
( Æ page 21)
Restores the default factory setting.
( Æ page 50)
Assign the frequently use functions
from options for shortcut.
( Æ page 48)
These buttons are used together with
▲▼◄► to adjust focus, zoom and
shift by the projection lens.
( Æ pages 40, 42)
Switches the image aspect ratio.
( Æ page 49)
Pressing this button toggles the
projector’s internal mechanical shutter
to black out the projector.
( Æ page 47)
Pressing this button while projecting
an image automatically corrects the
picture positioning on the screen.
While the auto setup feature is active,
a message “PROGRESS” appears on
the screen. ( Æ page 48)
Returns to the standby mode.
Makes the remote control available
to control any ID projectors.
( Æ page 21)
Displays projector information.
Enter ID number of the remote
control and adjustment values of
menu items.
Displays the test pattern.
( Æ page 48)
Displays and clears the on
screen indications.
( Æ page 47)
<MENU> button
Displays and clears the main menu, and
returns to the previous menu when the
menu is displayed.
Navigation and <ENTER> buttons
Navigate through the menu items with
▲▼◄►, and activate them with the
<ENTER> button. ( Æ page 50)
These buttons select the RGB1,
RGB2, DVI-D, VIDEO, S-VIDEO
and SDI terminals. ( Æ page 47)
Starts the projection while in the
standby mode.
Remote control indicator
Flashes by pressing any
buttons.