Nikon HT1000 - Manual (Page 17)

E-17
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of
the projector, and then connect the other plug of the supplied power
cable in the wall outlet.
PC CONTROL
RGB IN
DVI-D IN
SG TRIGGER
VIDEO IN S-VIDEO IN
S-VIDEO S-VIDEO
RGB/DVI RGB/DVI
VIDEO VIDEO
AUDIO IN AUDIO IN
COMPONENT
Y Cb/Pb Cr/Pr
When Viewing a DVI Digital Signal:
To project a DVI digital signal, be sure to connect the PC and the projec-
tor using a DVI-D signal cable (not supplied) before turning on your PC
or projector. Turn on the projector first and select DVI (DIGITAL) from
the source menu before turning on your PC.
Failure to do so may not activate the digital output of the graphics card
resulting in no picture being displayed. Should this happen, restart your PC.
Do not disconnect the DVI-D signal cable while the projector is running. If
the signal cable has been disconnected and then re-connected, an im-
age may not be correctly displayed. Should this happen, restart your PC. NOTE:
• Use the DVI-D cable compliant with DDWG (Digital Display Working Group)
DVI (Digital Visual Interface) revision 1.0 standard. The DVI-D cable should
be within 5 m (196") long.
• The DVI (DIGITAL) connector accepts VGA (640x480), SVGA (800x600), XGA
(1024x768) and HDTV 1080p, 1080i, 720p, 750p, 480p, 480i, 525p, 576p
and 625p.
PC CONTROL RGB IN DVI-D IN
SC TRIGGER
VIDEO IN S-VIDEO IN
S-VIDEO S-VIDEO RGB/DVI RGB/DVI VIDEO VIDEO AUDIO IN AUDIO IN COMPONENT
Y Cb/Pb Cr/Pr
AUDIO IN
PHONE
DVI-D IN
Audio cable (not supplied)
DVI-D Signal cable (not supplied)