E-21, Optimizing rgb picture automatically – Nikon HT1000 User Manual

Page 21

Advertising
background image

E-21

5. Press the ENTER button.

6. Use the SELECT

̆̄̇̈

button to move the projected image frame

as shown on the example.

7. Press the ENTER button.

Screen

The confirmation screen is displayed.

On the Cornerstone adjustment screen, select
“Exit” and then “OK”, or press the CANCEL but-
ton on the remote control.

8. Use the SELECT

̆̄̇̈

button to select another icon which points

in the direction.

Screen

9. Press the SELECT

̇

or

̈

button to highlight the [OK] and press the

ENTER button.

This completes the keystone correction.
Selecting “Cancel” will return to the adjustment screen without saving
changes (Step 3).
Selecting "Reset" will return to the factory default.
Selecting "Undo" will exit without saving changes.

NOTE: To return the 3D Reform correction setting values to the factory default,
press and hold the 3D REFORM button for a minimum of 2 seconds.

NOTE: During 3D Reform adjustment, "Aspect Ratio" and "Screen" may not be
available. Should this happen, first reset the 3D Reform data and then do each
setting. Second repeat the 3D Reform adjustment. Changing Aspect Ratio and/
or Screen setting can limit 3D Reform in its adjustable range.

The adjustable ranges for 3D Reform are as follows:
Horizontal ........... Max ±25° approx.
Vertical ............... Max ±40° approx.

* The following are conditions at the above maximum angle when all of

the following are met

• Image is projected in Wide (Zoom lever)

• Resolution is XGA

Higher resolution than XGA limits 3D Reform in its adjustable range.

• Menu items should be set as follows:

Aspect Ratio ............................... Normal

Screen Type ................................ 4:3

• Horizontal and Vertical are adjusted separately.

A combination of both adjustments limits 3D Reform in its adjustable
range.

• When "Stadium" is selected in Aspect Ratio, "Cornerstone" and "Hori-

zontal Keystone" are not available.

Optimizing RGB Picture Automatically

Adjusting the Image Using Auto Adjust

Optimizing RGB image automatically
Press the Auto Adjust button to optimize an RGB image automatically.

[Poor picture]

[Normal picture]

AUTO ADJ.

Press the Auto Adjust button to fine-tune the computer image or to re-
move any vertical banding that might appear and to reduce video noise,
dot interference or cross talk (this is evident when part of your image
appears to be shimmering). This function adjusts the clock frequencies
that eliminate the horizontal banding in the image. This function also
adjusts the clock phase to reduce video noise, dot interference or cross
talk. (This is evident when part of your image appears to be shimmer-
ing.)
This adjustment may be necessary when you connect your computer
for the first time.

NOTE:
• Some signals may not be displayed correctly or take time.
• The Auto Adjust function does not work for component and video signal.
• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock

and Phase manually. See page E-38.

Advertising