NETGEAR WPN802 - Manual (Page 16)

Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802
2-4 Introduction
202-10101-01, May 2005
The Front Panel Status Lights
You can use the status lights on the front panel of the WPN802 to verify connections. The table
below describes the lights on the front panel.
The Rear Panel
The rear panel of the WPN802 contains the items listed below.
Figure 2-1: WPN802 Rear Panel
Table 2-1. Status Light Descriptions
Label Activity Description
Power On Green Solid
Off Power is supplied and the WPN802 has passed its diagnostic test.
Power is not supplied to the WPN802 .
Test On
Off
The unit is performing the power on self test diagnostic.
The unit successfully completed the power on self test diagnostic.
WLAN On
Off The Wireless port is initialized and the wireless feature is enabled.
The wireless feature is turned off or there is a problem.
Ethernet On (Green)
Blink (Green)
On (Amber)
Blink (Amber)
Off The Ethernet port has detected link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Ethernet port has detected link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected.
4
Power Ethernet Port Reset Button
Seven integrated
antennas inside
LEDs show which
antenna is on.