Power off the wpn802 and power it back on, Release the reset button – NETGEAR WPN802 User Manual
Page 51
Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802
Troubleshooting
6-3
202-10101-01, May 2005
•
If the WPN802 is configured correctly, check your Internet connection (DSL/Cable modem,
etc.) to make sure that it is working.
•
Try again.
•
When entering configuration settings, be sure to click the Apply button before moving to
another menu or tab, or your changes are lost.
•
Click the Refresh or Reload button in the Web browser. The changes may have occurred, but
the Web browser may be caching the old configuration.
Using the Reset Button to Restore Factory Default Settings
The reset button on the rear panel of the WPN802 has two functions:
•
Reboot: When pressed and released quickly, the WPN802 will reboot (restart).
•
Reset to Factory Defaults: This button can also be used to clear ALL data and restore ALL
settings to the factory default values. These settings are shown in
To clear all data and restore the factory default values:
1. Power off the WPN802 and power it back on.
2. Use something with a small point, such as a pen, to press the reset button in and hold it in for
at least five seconds.
3. Release the reset button.
The factory default configuration has now been restored, and the WPN802 is ready for use.