Network Technologies CS-16/8 - Manual (Page 10)

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH
5
1. INSTALLATION
1.1 Rack Mounting Instructions
This NTI switch was designed to be directly mounted in a rack and includes a mounting flange to make attachment easy.
Install 4 cage nuts (supplied) to the rack in locations that line up with the holes (or slots) in the mounting flange on the NTI switch.
Then secure the NTI switch to the rack using four #10-32 x3/4” screws (supplied). Each screw should be of sufficient length to
go completely through the NTI mounting flange, rack frame and fully engage all threads in the captive nut. Be sure to tighten all
mounting screws securely.
Do not block power supply vents in the NTI switch chassis (if provided). Be sure to enable adequate airflow in front of and
behind the NTI switch.
Attach all cables securely to the switch and where necessary supply adequate means of strain relief for cables.
Figure 1- Mount Switch in a Rack
Cage Nuts
Rack Screws
Rack
(supplied) #10-32x3/4"
(supplied)