Optional equipment, Motion i/o connections, Optional equipment -4 motion i/o connections -4 – National Instruments 7334 User Manual
Page 12
Chapter 1
Introduction
7344/7334 Hardware User Manual
1-4
ni.com
Optional Equipment
National Instruments offers a variety of products for use with the
7344/7334 controller, including cables, Universal Motion Interfaces
(UMIs), drive power amplifier units, and other accessories as follows:
•
Cables and cable assemblies for motion and digital I/O
•
RTSI bus cables
•
UMI wiring connectivity blocks with integrated motion signal
conditioning and motion inhibit functionality
•
Stepper and servo motor compatible driver amplifier units with
integrated power supply and wiring connectivity
•
Connector blocks, shielded and unshielded 68-pin screw terminal
wiring aids
For more specific information about these products, refer to your National
Instruments catalog, on the Internet at
ni.com
, or call your National
Instruments sales representative.
Motion I/O Connections
The external motion and digital I/O connectors on the 7344/7334 controller
are high-density, 68-pin female VHDCI connectors.
For custom cables, use the following mating connector from AMP
(part number 787801-01).