Trigger, Figure 3-7. trg connector location and pinout, Table 3-8. trg connector signals – National Instruments NI PXIe-8105 User Manual
Page 43: Trigger -11
Advertising
Chapter 3
I/O Information
© National Instruments Corporation
3-11
Trigger
The TRG connector is the software-controlled trigger connection for
routing PXI triggers to or from the backplane trigger bus.
Figure 3-7 shows the TRG connector location on the NI PXIe-8105.
Table 3-8 lists and describes the trigger connector signals.
Figure 3-7. TRG Connector Location and Pinout
Table 3-8. TRG Connector Signals
Pin
Signal Name
Signal Description
1
TRIG
Trigger
2 (Shield)
GND
Ground
1
2
Advertising