Chapter 5 troubleshooting, What if the ni pxie-8105 does not boot, Secti – National Instruments NI PXIe-8105 User Manual
Page 55: Troubleshooting
© National Instruments Corporation
5-1
5
Troubleshooting
This chapter answers common troubleshooting questions you may have
when using the NI PXIe-8105 embedded computer.
What if the NI PXIe-8105 does not boot?
Several problems can cause a controller not to boot. Here are some things
to look for and possible solutions.
Things to Notice:
•
Which LEDs come on? The Power OK LED should stay lit.
The Drive LED should blink during boot as the disk is accessed.
•
What appears on the display? Does it hang at some particular point
(BIOS, Operating System, and so on.)? If nothing appears on the
screen, try a different monitor. Does your monitor work with a
different PC? If it hangs, note the last screen output that you saw for
reference when consulting National Instruments technical support.
•
What has changed about the system? Did you recently move the
system? Was there electrical storm activity? Did you recently add
a new module, memory chip, or piece of software?
•
Refer to your chassis user manual for additional troubleshooting steps.
Things to Try:
•
Make sure the chassis is plugged in to a working power source.
•
Check any fuses or circuit breakers in the chassis or other power
supply (possibly a UPS).
•
Make sure the controller module is firmly seated in the chassis.
•
Remove all other modules from the chassis.
•
Remove any nonessential cables or devices.
•
Try the controller in a different chassis.
•
Try a similar controller in this same chassis.
•
Clear the CMOS. (Refer to the
section of Chapter 2,
Installation and Configuration
.)
•
Recover the hard drive on the controller. (Refer to the