Nikon XX152-02-00 - Manual (Page 15)

2. If cables are used without the use of flexible conduit:
a. Remove the enclosure top by loosening the 3 screws. Remove the conduit fitting by loosening
the nut and sliding it out. Install the supplied strain relief fitting in its place and re-attach the top
and route cables through the strain relief fitting.
2.
a. e enclosure near the hole in the ceiling and route conduit cables through the conduit
th
12 in. (305 mm). Tighten the clamp screw.
3. Lift
the
4. Con
from e
cover.
b. Hold the enclosure near the hole in the ceiling
If cables are channeled through flexible cable:
Hold th
fitting.
b. Insert the end of the flexible conduit pipe into the conduit fitting. Cable length should be flush wi
the bottom of the enclosure, approximately
the enclosure up through the ceiling hole. Turn and tighten the flipper screws to obtain a flush fit with
ceiling plane.
nect the enclosure’s safety cord clip to the tab in the camera mechanism to allow the drive to hang
th enclosure. Refer to Figure 2 for location of tab.
Continue with section on Cable Connections.
Figure 2
Safety Cord Installation
there is access to
Mounting from Above the Ceiling
Use this method of installation if the space above. The ceiling material must provide
suitable strength to support the weight of the SurveyorVFT fixed dome with the two flippers on the enclosure.
Refer to the section on Optional Indepen
ns requiring additional support. Be sure
the area around the selected location is clear of obstacles (such as steel beams, headers, pipes, electrical
o, sync, and power cables must be routed to the location.
allow the mechanism to hang from the enclosure. Align the 2 slots on the camera mechanism with the
tabs in the enclosure, being sure to match up the arrows on both the drive and in the enclosure. Insert the
camera mechanism into the enclosure until it snaps into place.
dent Support for installatio
wiring, etc.) that would interfere with mounting. Vide
1. Mark with the scribe and cut a 7-3/8 in. (187 mm) hole in the ceiling at the desired location. Remove tile
from dropped ceiling if necessary. Feed all necessary flexible conduit pipe or cables down through the
hole.
2. Lift the SurveyorVFT enclosure up to the ceiling and snap it into the hole. Turn and tighten the flipper
screws for a flush fit. Connect the enclosure’s safety cord clip to the tab in the camera mechanism to
XX152-02-00 Rev 1004 SurveyorVFT Fixed Camera Dome Installation • 5