Nikon XX152-02-00 - Manual (Page 24)

Indoor Pendant
After all the cabling is complete, push the SurveyorVFT camera mechanism straight up into the housing. Align
camera mechanism with the tabs in the enclosure, being sure to match up the arrows on
both the mechanism and in the enclosure. Insert the camera mechanism into the enclosure
there is no extra slack in the cabling that will interfere with proper installation and
the 2 slots on the
until it snaps into
place. Refer to Figure 10.
Note: Assure that
operation. Push any extra cabling up into the mount or pipe.
After the SurveyorVFT is in place, the camera/lens can be adjusted. The camera position can be adjusted
horizontally and vertically and rotation about the lens axis (roll). With the camera powered on and video
displayed in a monitor, turn the camera to point in the desired direction. The tilt position can also
Loosen the two nuts, if necessary, on either side of the camera mounting frame (use an open end 11/32
Position the camera and retighten nuts. The camera mounting bracket position can be adjusted
relative to the closeness to the dome by loosening the lock nuts and changing the ve
camera mounting frame within the slots in the mounting bracket. Refer to Figure 8.
The lens can be manually adjusted. On the 5-50 mm lens, the telephoto/wide adjustment
and close) is the middle ring and focus (near to infinity) is the end ring. On the 2.6-6 mm lens, focus
the telephoto/wide adjustment is the end ring; iris is fixed. Refer to
r is provided for iris adjustment.
camera/lens is properly adjusted, the lower dome can be installed. Lift the lower dome up to the
he safety cord from the lower dome in
be adjusted.
wrench).
rtical position of the
is the front ring, iris
(open
(near to infinity) is the front ring and
Figure
7. On autoiris lenses, a potentiomete
After the
SurveyorVFT and insert the clip of t
to the hole provided on the inside of
the housing to anchor the lower dome. See label inside housing. Holding the lower dome, align the two (2)
molded tabs on the lower dome with the recess
inner enclosure. Press the lower dome into the
SurveyorVFT and v
es on the
erify that it snaps into place on both sides. Refer to Figure 10.
Figure 10
Pendant Mount Dome Final Installation
14 • Installation XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome