Nikon XX152-02-00 - Manual (Page 16)

3. Working above the ceiling, remove the enclosure top by loosening the 3 screws and lifting it off.
If cables are used without the use of flexible conduit: 4.
uit cables through the conduit fitting.
Continue with the section on Cable Connections.
Optiona
If it is necessary to provide independent support for the SurveyorVFT fixed dome other than ceiling material,
del SVFT-IC-MKT. It consists of a pre-assembled set of
mountin
1. With
ush
the folded assembly up through the hole and unfold.
2. Position the assembly squarely over the hole and fasten the caddy rail clips to the existing frame.
ps.
ed against the tile without warping the tile. Refer to
Figure 3B.
6. e previous procedure. When using this kit, the flippers
squeeze the mounting ring assembly for a snug fit.
a. Remove the conduit fitting by loosening the nut and sliding it out. Install the supplied strain relief
fitting in its place and re-attach the top cover.
b. Route approximately 12 in. (305 mm) of cables through the strain relief fitting. Tighten the two (2)
strain relief fitting screws to compress the cables. Do not overtighten the screws and crush the
cables.
4. If cables are channeled through flexible cable:
a. Route approximately 12 in. (305 mm) of cond
b. Insert the end of the flexible conduit pipe into the conduit fitting and tighten the clamp screw.
l Independent Support
order the optional In-Ceiling Mount Model Kit, mo
g rails and folding ring. Refer to Figure 3A.
the 7-3/8-inch (187 mm) diameter hole cut in the ceiling tile and the tile replaced in the ceiling, p
Remove the adjacent tiles to access the cli
3. Adjust the position of the caddy rail clips along the frame to obtain the best “X” position.
4. Slide the assembly along the caddy rails to obtain the best concentric “Y” position. Tighten the horizontal
adjustment screws to secure the position.
5. With the ring concentric with the hole, slide the ring vertically along the support slots to obtain the best
flush fit in the ceiling. The ring should be firmly seat
Complete the installation as described in th
Figure 3A
Installation of Optional In-Ceiling Mounting Kit
6 • Installation XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome