Nikon XX152-02-00 - Manual (Page 25)

Outdoor Pendant
Note: Assure that there is no extra slack in the cabling that will interfere with proper installation and
After all the cabling is complete, push the SurveyorVFT camera mechanism straight up into the housing. Align
the 2 slots on the camera drive with the tabs in the enclosure, being sure to match up the arrows on both the
drive and in the enclosure. Insert the camera drive into the enclosure until it snaps into place.
operation. Push any extra cabling up into the mount or pipe.
fter the SurveyorVFT is in place, the camera lens can be adjusted. The camera position can be adjusted
he lens can be manually adjusted. On the 5-50 mm lens, the telephoto/wide adjustment is the front ring, iris
fter the camera/lens is properly adjusted, the lower dome can be installed. Lift the lower dome up to the
A
horizontally and vertically and rotation about the lens axis (roll). With the camera powered on and video
displayed in a monitor, turn the camera to point in the desired direction. The tilt position can also be adjusted.
Loosen the two nuts, if necessary, on either side of the camera mounting frame (use an open end 11/32
wrench). Position the camera and retighten nuts. The camera mounting bracket position can be adjusted
relative to the closeness to the dome by loosening the lock nuts and changing the vertical position of the
camera mounting frame within the slots in the mounting bracket. Refer to Figure 8.
T
(open and close) is the middle ring and focus (near to infinity) is the end ring. On the 2.6-6 mm lens, focus
(near to infinity) is the front ring and the telephoto/wide adjustment is the end ring; iris is fixed. Refer to Figure
7. On autoiris lenses, a potentiometer is provided for iris adjustment.
A
SurveyorVFT and insert the clip of the safety cord from the lower dome into the hole provided on the inside of
the housing to anchor the lower dome. See label inside housing. Holding the lower dome, align the two (2)
molded tabs on the lower dome with the recesses on the inner enclosure. Press the lower dome into the
SurveyorVFT and verify that it snaps into place on both sides. Tighten the four (4) trim ring screws to hold the
lower dome in place. Refer to Figure 10.
XX152-02-00 Rev 1004 SurveyorVFT Fixed Camera Dome Installation • 15