Netopia 4541 - Manual (Page 104)

9-20 User’s Reference Guide
Binding Map Lists and Server Lists
Once you have created your map lists and ser ver lists, for most Netopia Router models you must bind them to
a profile, either a Connection Profile or the Default Profile. You do this in one of the following screens:
■ the IP profile parameters screen (see below) of the Connection Profile configuration menu
■ the IP Parameters (WAN Default Profile) screen (see page 9-22 ) of the Default Profile configuration menu
■ the Binding Map Lists and Ser ver Lists screen (see page 9-20 )
IP profile parameters
To bind a map list to a Connection Profile, from the Main Menu go to the WAN Configuration screen then the
Display/Change Connection Profile screen. From the pop-up menu list of your Connection Profiles, choose the
one you want to bind your map list to. Select IP Profile Parameters and press Return.
The IP Profile Parameters screen appears.
Main
Menu
WAN
Configuration
IP Profile
Parameters
Display/Change
Connection Profile
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Unnumbered
NAT Map List... Easy-PAT List
NAT Server List... Easy-Servers
Local WAN IP Address: 206.1.1.6
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 127.0.0.2
Remote IP Mask: 255.255.255.255
Filter Set... Basic Firewall
Remove Filter Set
RIP Profile Options...
Configure IP requirements for a remote network connection here.