Netopia 4541 - Manual (Page 32)

6-4 User’s Reference Guide
Routed 1483. If you select Bridged 1483, a new option PPP over Ethernet (PPPoE) appears. You can
then toggle PPPoE On or Off. Choosing Routed 1483 hides the PPPoE option.
■ If you selected PPP, the next pop-up menu PPP Mode offers the choice of VC Multiplexed or LLC SNAP.
3. The next two fields, Data Circuit VPI and Data Circuit VCI are editable. Enter the Vir tual Path Identifier and
Vir tual Channel Identifier values that your provider specifies.
4. Press the Down arrow key until you reach NEXT SCREEN. Press Return to bring up the next screen.
Easy Setup Profile
The Easy Setup Profile screen is where you configure the parameters that control the Netopia 4541/4542’s
connection to a specific remote destination, usually your ISP or a corporate site.
On a Netopia 4541/4542 you can add up to 15 more connection profiles, for a total of 16, although you can
only use one at a time, unless you are using Vir tual Private Networks (VPNs).
Note: The appearance of this screen varies, depending on the settings in the previous screen.
1. To enable address translation, toggle Address Translation Enabled to Yes (the default). For more
information on Network Address Translation, see
Chapter 9, “Multiple Network Address Translation.”
2. From the IP Addressing menu item, choose between Unnumbered and Numbered addressing. Numbered is
the default for ADSL. It assigns a unique IP address to the ADSL WAN inter face, as required by most ISPs’
routers. Unnumbered may be used for simpler configurations such as point-to-point applications.
Connection Profile 1: Easy Setup Profile
Connection Profile Name: Easy Setup Profile
Address Translation Enabled: Yes
IP Addressing... Numbered
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
PPP Authentication... None
PREVIOUS SCREEN NEXT SCREEN