NetComm 3G Wireless Router User N3G005W - Manual (Page 25)

YML894 Rev3 N3G005W 3G Wireless Router User Guide N3G005W 3G Wireless Router User Guide
www.netcomm.com.au 5
N3G005W
1. LAN IP Address: the local IP address of this device.
2. LAN Netmask: the Netmask of the local IP address
3. WAN’s MAC Address: The WAN’s MAC of this device. If you want to clone the MAC address from your
computer network card, just click the Clone MAC and click Save.
4. Auto-Backup: tick to enable wired-Wan back up function. Enter an IP address where the unit will check
for wired-WAN connection.
5. WAN Type: WAN connection type of your ISP. Each WAN type will give you the option to enter the required
information. You can select one of the following options.
a. Static IP Address. For connection with static IP address.
b. Dynamic IP Address. For connection with dynamic IP address. Mostly used when the N3G005W unit
is in use in conjunction with another modem/router.
c. Dynamic IP Address with Road Runner Session Management. When using the N3G005W with Telstra
Bigpond Cable service.
d. PPP over Ethernet. For connection with PPPoE service. Mostly used when the N3G005W unit is
connected to a Bridge ADSL modem.
e. L2TP. For connection with L2TP service.
f. PPTP. For connection with PPTP service.
g. 3G. For connection with 3G service.
h. iBurst. For connection with iBurst service.
Notes: All of the connection types above are used in conjunction with a modem or another router connected to the WAN port except for 3G which
needs a 3G USB modem installed. Static IP Address, Dynamic IP address, Dynamic IP Address with Road Runner Session Management and
PPP over Ethernet has an Enable Backup option to set it as the primary connection and the 3G USB modem as the backup connection.