NetComm 3G Wireless Router User N3G005W - Manual (Page 78)

N3G005W 3G Wireless Router User Guide YML894 Rev3
8 www.netcomm.com.au
Legal & Regulatory Information
This manual is copyright. Apart from any fair dealing for the purposes
of private study, research, criticism or review, as permitted under the
Copyright Act, no part may be reproduced, stored in a retrieval system
or transmitted in any form, by any means, be it electronic, mechanical,
recording or otherwise, without the prior written permission of NetComm
Limited. NetComm Limited accepts no liability or responsibility, for
consequences arising from the use of this product.
NetComm Limited reserves the right to change the specifications and
operating details of this product without notice.
NetComm is a registered trademark of NetComm Limited.
All other trademarks are acknowledged the property of their respective
owners.
Customer Information
ACA (Australian Communications Authority) requires you to be aware of
the following information and warnings:
(1) This unit shall be connected to the Telecommunication Network
through a line cord which meets the requirements of the ACA
TS008 Standard.
(2) This equipment has been tested and found to comply with the
Standards for C-Tick and or A-Tick as set by the ACA . These
standards are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio noise and, if not installed
and used in accordance with the instructions detailed within
this manual, may cause interference to radio communications.
However, there is no guarantee that interference will not occur
with the installation of this product in your home or office. If this
equipment does cause some degree of interference to radio or
television reception, which can be determined by turning the
equipment off and on, we encourage the user to try to correct the
interference by one or more of the following measures:
• Change the direction or relocate the receiving antenna.
• Increase the separation between this equipment and the
receiver.
• Connect the equipment to an alternate power outlet on a
different power circuit from that to which the receiver/TV is
connected.
• Consult an experienced radio/TV technician for help.
(3) The power supply that is provided with this unit is only intended
for use with this product. Do not use this power supply with any
other product or do not use any other power supply that is not
approved for use with this product by NetComm. Failure to do so
may cause damage to this product, fire or result in personal injury.