NetComm 3G Wireless Router User N3G005W - Manual (Page 53)

YML894 Rev3 N3G005W 3G Wireless Router User Guide N3G005W 3G Wireless Router User Guide
www.netcomm.com.au 53
N3G005W
Advanced.Setting.>.QoS
To Enable QoS make sure the Enable Tick Box on the top of the page is ticked.
Upstream.bandwidth Total bandwidth of outgoing traffic.
Downstream.
bandwidth Total bandwidth of incoming traffic.
You can specify 8 QoS rules to control data flows through the Router.
Local IP: IP address of LAN host
Local Port: TCP or UDP port
Remote IP: IP address of WAN host
Remote Port: TCP or UDP port
QoS.Priority The QoS Packet Filter classifies data packets to three kinds of data flows (High,Normal,Low). The ratio of
bandwidth division of each data flow is 6:3:1
Enable Make sure you tick the Enable tick box so that the QoS Filter is active.
Click Save to save or Undo to cancel.
For source or destination port, you can define a single port (80) or a range of ports (1000-1999).And you need to add prefix “T” or “U” to specify
TCP or UDP protocol e.g. T80,U53,U2000-2999. No prefix indicates both TCP and UDP are defined. An empty implies all port addresses.