Operating the power lift gate, If so equipped) -16 – NISSAN vehicle User Manual

Page 150

Advertising
background image

OPERATING THE POWER LIFT

GATE (if so equipped)

NOTE:

To open, close or reverse the power lift
gate, the shift selector lever must be in P
(Park). Also, the power lift gate will not
operate if battery voltage is low.

Power Open:
The power lift gate automatically moves from the

fully closed position to the fully open position in

approximately 5 – 8 seconds. The power open

feature can be activated by the switch on the

keyfob and the overhead console and by the

outside opener handle. The hazard lights flash

and a chime sounds to indicate the power open

sequence has been started.

● The lift gate can be opened by the overhead

console switch and the keyfob even if the

vehicle is locked. The lift gate will individually

unlock and open. Once the lift gate is

closed, its lock will align to the vehicle’s lock

or unlock status.

● The keyfob button must be held for 0.5 sec-

ond before the lift gate opens.

● The lift gate must be unlocked to open it with

the outside opener handle.

● The switch on the rear pillar cannot be used

to open the lift gate.

A warning chime will sound if the shift selector

lever is moved out of P (Park) during a power

open operation.
Power Close:

The power lift gate automatically moves from the

fully open position to the secondary position.

When the lift gate reaches the secondary posi-

tion, the cinching motor engages and pulls the lift

gate to its primary latch position. Power close

takes approximately 7 – 10 seconds. The power

close feature can be activated by the switch on

the keyfob, the overhead console and the rear

pillar. The hazard lights flash and a chime sounds

to indicate the power close sequence has been

started.

● If the outside opener handle is activated

while the cinching motor is engaged, the

cinching motor will disengage and release

the latch.

● The keyfob button must be held for 0.5 sec-

ond before the lift gate closes.

● The switch on the rear pillar can only be used

to close the lift gate if the main ON/OFF

switch is ON.

Rear pillar switch

WPD0339

Overhead console switch

WPD0340

3-16

Pre-driving checks and adjustments

REVIEW COPY—

2007 Quest (van)

Owners Manual—USA_English (nna)
02/27/06—debbie

Advertising