Neuton EM 5.1 - Manual (Page 17)

NEUTON EM 5.1 Cordless Electric Mower Safety & Operating Instructions 13
Step 2: Remove the Battery
You can quickly and easily remove the battery
from your Mower.
1. Open the battery cover (Figure 2).
Remember to press down on the Mower body
next to the battery cover handle before pulling
the cover open.
2. Turn the battery retainer arm until it is no
longer blocking the battery (Figure 3).
To help keep the Mower from rolling while
removing the battery, put one foot behind a wheel for
stability.
3. Pull the battery straight up to remove it.
Step 3: Charge the Battery Before
Your First Use
You MUST charge the battery for 12 hours before you use
the Mower for the first time. If you do not charge it before
using the Mower, the battery’s charging capacity may
decrease.
For instructions on removing and charging the battery,
read “Chapter 5: Charging and Caring for the Battery”
before you operate the mower.
Step 4: Attach the Lower
Handlebar Sections
To keep the Mower from moving while you
assemble it, put a foot behind one of the wheels.
Use the green quick-connect knobs to attach the
lower handlebar sections to the Mower. You
install both handlebars the same way.
1. Set the cutting height lever to the highest
adjustment: position 6 as molded into the
Figure 2. Lift the battery cover
Figure 3. Turn the battery retainer
arm
Figure 4. Set cutting height to position 6
(Note: position numbers have been
highlighted for clarity)