Neuton EM 5.1 - Manual (Page 18)

14 NEUTON EM 5.1 Cordless Electric Mower Safety & Operating Instructions
Mower body (Figure 4). This makes it easier
to reach the slots on the Mower frame.
2. Position the lower handlebar with the
smooth side against the frame of the
Mower. Slide it down fully into the slot on
the frame until the holes line up (Figure 5).
Be sure you slide the handlebar all the way
down to the bottom of the slot. When you
do this, the cutout notch on the end of the
handlebar aligns with the base of the
channel in the Mower’s frame.
Place the lower handlebar with the cord clip
on the right side (from the operator’s point
of view) of the mower.
3. Insert a lock washer and a green quick-
connect knob through the lined-up holes in
the handle and Mower frame to attach each
side of the lower handlebar to the Mower.
4. Hand tighten the green quick-connect knob
until firmly snug (Figure 6).
5. Attach the other handlebar in the same
manner.
Important: Be sure to tighten the green
quick-connect knobs by hand. Do not use a
tool to tighten; you could easily over tighten
them and damage the parts.
Step 5: Attach the Upper Handlebar Assembly
Use the black connector knobs (already attached
to the lower handlebars) to connect the upper
and lower handlebar sections together.
1. Remove the black connector knobs and
connector bolts from the upper ends of the
lower handlebars.
Let the upper handlebar assembly lean on the
ground during this process (Figure 7). It is easier
to start with the upper assembly in this position,
so you don’t have to hold and balance it while
connecting the sections. Once you have the
handlebars loosely connected, you can swing the
upper assembly into place and tighten it further.
2. Line up the holes of the upper handlebars
Figure 6. Tighten the green quick-connect
knobs
Figure 7. Lean the upper handlebar assembly
onto the lower handlebars (shown after the
black connector knobs and bolts are attached)
Figure 5. Slide the handlebar fully into the slot
on the Mower