Neuton EM 5.1 - Manual (Page 25)

NEUTON EM 5.1 Cordless Electric Mower Safety & Operating Instructions 21
Chapter 4: Operating Your NEUTON Mower
This chapter explains how to start, stop, and adjust the cutting height of your Mower.
Note: If the Mower battery is not fully charged or if you are unpacking a new Mower for the first
time, read “Chapter 5: Charging and Caring for the Battery” before operating the Mower. You
should charge the battery for a minimum of 12 hours before using it in the Mower.
Pre-Start Checks
Perform the following checks before operating your Mower each time.
• Check under the Mower deck and make sure you are using the correct blade (for mulching or
cutting) and that the blade is attached securely. Make sure all knobs, bolts, attachments, and
covers are in place and securely attached. Inspect for any visible damage to the blade or deck,
and remove any accumulation of dirt, dust, or dried grass clippings.
• Attach either the rear discharge plate, the rear bagger, or the mulching blade and plug. (See
“Chapter 6: Optional Attachments” for details on attaching the bagger and mulching kit.)
• Set the Mower to the desired cutting height. (See “Adjusting the Cutting Height” on page 22 for
details.)
• Be sure the battery is fully charged.
• Be sure the Mower/Auxiliary Switch is set to “Mowing” (the “Mowing” side of the switch is
pushed down).
• Push the Mower (before starting it) to the lawn area to be mowed.
Note: The length of time that a battery can hold its charge while mowing depends upon lawn
conditions; tall or thick grass makes the Mower work harder causing the battery to discharge faster.
WARNING! Do not insert the safety key until you have completed all of the pre-
start checks and you have moved the Mower to the area being mowed.