National Instruments Isolated Current Output Module SCC-CO20 - Manual (Page 2)

SCC-CO20 Isolated Current Output Module User Guide 2 ni.com
italic Italic text denotes variables, emphasis, a cross-reference, or an introduction
to a key concept. Italic text also denotes text that is a placeholder for a word
or value that you must supply.
monospace Text in this font denotes text or characters that you should enter from the
keyboard, sections of code, programming examples, and syntax examples.
This font is also used for the proper names of disk drives, paths, directories,
programs, subprograms, subroutines, device names, functions, operations,
variables, filenames, and extensions.
SC-2345 SC-2345 refers to both the SC-2345 connector block and the SC-2345 with
configurable connectors.
SCC SCC refers to any SCC Series signal conditioning module.
What You Need to Get Started
To set up and use the SCC-CO20, you need the following items:
❑
Hardware
– SC-2345/2350 with one of the following:
• SCC-PWR01
• SCC-PWR02 and the PS01 power supply
• SCC-PWR03 (requires a 7 to 42 VDC power supply,
not included)
– One or more SCC-CO20
– 68-pin E/M Series DAQ device
– 68-pin cable
– Quick Reference Label
❑
Software
– The latest version of NI-DAQmx
❑
Documentation
– SCC-CO20 Isolated Current Output Module User Guide
– SC-2345/2350 User Manual
– SCC Quick Start Guide
– Read Me First: Safety and Radio-Frequency Interference
– Documentation for your hardware
– Documentation for your software