National Instruments Order Analysis Toolset - Manual (Page 10)

Chapter 1 Introduction to the LabVIEW Order Analysis Toolset
© National Instruments Corporation 1-3 LabVIEW Order Analysis Toolset User Manual
System Requirements
You must have LabVIEW 6.1 or later Full Development System or
Professional Development System installed to run the LabVIEW Order
Analysis Toolset.
Note Refer to the LabVIEW Release Notes for the required system configuration for
LabVIEW.
Note Order analysis is a memory-intensive task, especially when you display spectral
maps. Increasing the amount of RAM in your system can significantly increase system
performance.
Installation
This section provides instructions for installing the LabVIEW Order
Analysis Toolset.
Note Some virus detection programs interfere with the installer. Disable any automatic
virus detection programs before you install. After installation, check your hard disk for
viruses and enable any virus detection programs you disabled.
(Windows 2000/NT/XP) Complete the following steps to install the LabVIEW
Order Analysis Toolset.
1. Log on as an administrator or as a user with administrator privileges.
2. Insert the LabVIEW Order Analysis Toolset 2.0 installation CD into
the CD-ROM drive and follow the instructions that appear on the
screen. If the startup screen does not appear, select Start»Run,
navigate to the
Setup folder on the LabVIEW Order Analysis
Toolset 2.0 installation CD, and double-click OAT.exe .
(Windows Me/98) Insert the LabVIEW Order Analysis Toolset 2.0
installation CD and follow the instructions that appear on the screen. If the
startup screen does not appear, select Start»Run, navigate to the
Setup
folder on the LabVIEW Order Analysis Toolset 2.0 installation CD, and
double-click
OAT.exe .