National Instruments Order Analysis Toolset - Manual (Page 12)

Chapter 1 Introduction to the LabVIEW Order Analysis Toolset
© National Instruments Corporation 1-5 LabVIEW Order Analysis Toolset User Manual
set to DAQ and you click the Run button on the front panel of the
example VI, one of the following VIs opens:
• Acquire Data (Analog Tach) VI
• Acquire Data with PXI 4472 and TIO VI
Refer to the Acquire Data (Analog Tach) VI section for information about
the Acquire Data (Analog Tach) VI and the
Acquire Data with PXI 4472
and TIO VI section for information about the Acquire Data with PXI 4472
and TIO VI.
Acquire Data (Analog Tach) VI
In analog tachometer examples, setting Data Source to DAQ and clicking
the Run button opens the Acquire Data (Analog Tach) VI. The Acquire
Data (Analog Tach) VI helps you acquire vibration data with a digital
tachometer signal. Figure 1-1 shows the Configuration tab of the Acquire
Data (Analog Tach) VI.
Figure 1-1. Acquire Data (Analog Tach) VI Configuration Tab
You must configure two channels of the DAQ device before you acquire
data. Use the Configuration tab of the Acquire Data (Analog Tach) VI,
shown in Figure 1-1, to configure your DAQ device. In the Channel
Settings section of the Configuration tab, use Tachometer for the