Nortel Networks 6140 - Manual (Page 112)

112
Dual Charger
Using the Dual Charger
To charge the WLAN Handset 6120
and 6140 1. Place the handset, face forward, into the
front slot of the Dual Charger.
The handset can be off or in standby
mode during charging. The LED
displays the charging status. See
instruction Single charger.
2. Charge the handset battery.
If the handset is in standby mode, it
displays its extension number and
Charging. It is fully operational and can
receive calls. If the handset is off, only
Charging is displayed and the handset
cannot receive calls.
It is normal for the battery pack to
become warm when charging.
3. When the handset is fully charged,
Charge Complete is displayed.
Remove the handset from the charger.
The battery pack starts to charge.
Cleaning the Dual Charger
Clean the Dual Charger by wiping the surface with a plain-water-dampened cloth or
paper towel. A mild detergent solution can be used. Be sure to wipe away any
detergent residue with a plain-water-dampened cloth.
You can clean the battery pack contacts on the handset with isopropyl (rubbing)
alcohol applied with a cotton swab, cloth, or paper towel. Do not push or pull the
CAUTION
Do not immerse the charger in water or other liquid.
Do not pour liquids into the charger slot.