Nortel Networks 6140 - Manual (Page 18)

18
Regulatory and safety information
measurement known as the Specific Absorption Rate (SAR). The SAR limit set by
the FCC is 1.6W/kg. Tests for SAR are conducted by using standard operating
positions specified by the FCC with the telephone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the telephone while operating
can be well below the maximum value. This is because the telephone is designed to
operate at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless Base Station antenna, the lower
the power output. Before a telephone model is available for sale to the public, it must
be tested and certified to the FCC that it does not exceed the limit established by the
government-adopted requirement for safe exposure. The tests are performed in
positions and locations (e.g., at the ear and worn on the body) as required by the FCC
for each model. While there may be differences between the SAR levels of various
telephones and at various positions, they all meet the government requirement for
safe exposure.
The FCC has granted an Equipment Authorization for this model phone with all
reported SAR levels evaluated as in compliance with the FCC RF emission
guidelines. SAR information on this model telephone is on file with the FCC and can
be found under the Display Grant section of http://www.fcc.gov/oet/fccid after
searching on FCC ID IYG702X or FCC ID IYG703X.
Additional information on Specific Absorption Rates (SAR) can be found on the
Cellular Telecommunications Industry Association (CTIA) website at
http://www.ctia.org/.
The only authorized headsets that may be utilized with the Nortel WLAN Handset
6120 or 6140 are those obtainable from Nortel Networks or its reseller partners.