Figure 8-1. model with enabled and triggered tasks – National Instruments AutoCode NI MATRIX User Manual
Page 214
Advertising
Chapter 8
AutoCode Sim Cdelay Scheduler
8-4
ni.com
Figure 8-1. Model with Enabled and Triggered Tasks
Under the default AutoCode scheduler, the output of this system is as
shown in Figure 8-2. The top signal (corresponding to the triggered task)
shows a latency of two cycles relative to its trigger input (immediately
below), while the lower signal (corresponding to the enabled task) shows a
latency of three cycles relative to its enable input. You will observe in the
Advertising