Nortel Networks ICS 4.1 - Manual (Page 67)

Page 61
P0906186 Issue 02 Compact ICS 4.1 Programming Record
•••• Ring grp 01 Enter the valid ring group number from 01 to 20. All ring groups have DN 21 assigned to them.
••••• Show set:_ Enter the number of the set you wish to assign to this Ring group or use LIST to display the valid
sets added to this Ring group.
•• Sched:Night In this setting, you select options for your ringing service.
••• Service Select how you want your service activated.
••• Trunk answer Select Y (Yes) to allow you use the Trunk Answer feature (Д¡вв) to answer, from
any telephone, an external call ringing at any other telephone in the system when ringing
service is on.
••• ExtraDial Enter the internal telephone number of the Extra-Dial telephone. This allows you to assign an
additional Direct-dial telephone in the Norstar system for each schedule you use.
••• Line settings Select ringing service options for each line.
•••• Show line:_ Enter a valid line number.
••••• Ring grp Enter the line number of a pre-defined ring group between 01 and 20.
••••• Aux. ringer Indicate whether the auxiliary ringer (if installed) also rings for this line when Ringing service is
on.
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
Select the ringing service settings for each of these schedules as you have done for Night sched.
• Restrn service Programming section where you can select the method for activating alternate restrictions.
•• Sched:Night In this section you can indicate how alternate call routing should be activated for each of the
schedules.
••• Service Select how you want your service activated.
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
Set up activation method for each of these schedules, as you have with Night sched.
• Routing service A programming section that lets you create up to 500 destination codes and 999 routes to
provide a dialing plan or “least cost routing”.
•• Routes Create the routes to be used when a destination code is dialed.
••• Show route:_ Enter the number of the route you want to create.
•••• DialOut Enter the number (up to 24 digits or characters) you want this route to dial out (if required).
•••• Use Select the line pool you want this route to use.
•• Dest codes Define which routes are used when a destination code is dialed.