Nortel Networks ICS 4.1 - Manual (Page 68)

Page 62
Compact ICS 4.1 Programming Record P0906186 Issue 02
••• Show DstCode:_ Up to 500 destination codes are programmable.
Enter the digits (up to 7 digits) of the destination code that you want to define. No two
destination codes can be identical. A destination code cannot begin with a digit assigned as
the Call Park prefix, or a Direct-dial digit. It cannot be the same as, or be the start digits of a
DN, the DISA DN or the Auto DN, a line pool code, or a received number.
•••• Normal For the last destination code, define the normal service. You will usually use the route that has
the lowest cost for the times when normal service is in use.
•••• AbsorbLength Enter the number of digits from the destination code that will not be dialed as part of the
outgoing number.
•••• Night
•••• Evening
•••• Lunch
•••• Sched 4
•••• Sched 5
•••• Sched 6
For this destination code, define a route for each of the schedules, as you have done for normal
service.
•• Sched:Night This schedule can be activated automatically or manually, or it can be left in the default Off.
••• Service Select how you want this service activated, if applicable.
••• Overflow For each schedule, choose whether you want a destination code to use the route assigned to
normal service when the route assigned to the schedule is busy.
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
Select how you want each of the scheduled services to be activated, and whether a destination
code uses the route used with normal service when the route used with the schedule is busy.
• Common settings In this programming section, you can assign settings that are shared by different services.
•• Control sets Assign control telephones to turn services on or off.
••• For lines Select a control set for each line.
•••• Show line:_ Enter the number of the line you want to program.
••••• L001 Assign a control telephone to each external line. This telephone is where you turn services on
and off for the line.
••• For sets Select a control set for each set.
•••• Show set:_ Enter the number of the telephone you want to program.
••••• <internal #> Assign a control telephone to each telephone. This telephone controls Restriction service and
Routing service for the set.
•• Schedule names The schedule name is shown on the display of the control telephone when the schedule is turned
on. It identifies the active schedule.