Nortel Networks ICS 4.1 - Manual (Page 75)

Page 69
P0906186 Issue 02 Compact ICS 4.1 Programming Record
Software Keys In this section, you can access optional features and services.
• SysID This number can be viewed on any M7324 or M7310 telephone display. Record the number,
which you will be asked to provide when you call the Nortel Customer Response Center.
• Password Keys The keys are obtained by calling the Nortel Customer Response Center at 1-800-321-2649.
The keys are required for some system expansion activities and to activate the remote
monitoring capability.
•• Key 1 Enter the eight-digit password.
•• Key 2 Enter the eight-digit password.
•• Key 3 Enter the eight-digit password.
Hardware In this section, you can view and configure the Trunk Cartridges and BRI Cards installed in the
ICS.
• Cd1-KSU Configure the cartridge or card that occupies the left-most slot in the ICS.
•• Card type The display shows the current card type.
•• Lines View the line-number range for the lines on an LS/DS or CI Analog Trunk Cartridge.
•• Discon timer Specify the duration of an Open Switch Interval for an LS/DS or CI Analog Trunk Cartridge.
•• Loops View the loops on this BRI Card.
•• Loop View the settings for a particular loop on this BRI Card.
••• Type View or change the loop type.
•••• Lines View the lines on this loop (only for S, T, and U-NT loops).
••• No SPIDs assignd Assign one or two service profile identifiers (SPIDs) as supplied by your service provider. SPID
settings appear only for S, T, and U-NT loops.
••• SPID1 Enter the SPID supplied by your service provider.
••• # of B-channls Select the number of B-channels that are associated with the SPID.
••• Network DNs Enter the Network DNs that are associated with the SPID.
•••• Call type Select the Call type used with the Network DN. For each Network DN, use only one of each of
the Voice and Data call type settings, or a single Both call type setting.
••• SPID2 Enter the second SPID supplied by your service provider, if applicable.
••• D-packet srvce Configure the D-packet service for this loop.
•••• D-packet srvc Turn the D-packet service for this loop on or off.
•••• Lp201 Select the S-loop (for BRI-ST Card) or U-LT loop (for BRI-U2 or BRI-U4 Card) that supports the
D-packet service.
•••• TEIs Add up to eight Terminal Endpoint Identifiers (TEIs). Each TEI is supplied by your service
provider and is associated with an ISDN device.
••••• No TEIs on loop Enter the two-digit TEIs supplied by your service provider.
••• ONN blk Determine the ONN blocking for BRI loops.
••• Sampling Select the sampling used by an S loop.
••• DNs on Loop 201 Assign the ISDN DNs that use this S loop or U-LT loop.
•••• Assign DNs Enter up to seven ISDN DNs for each S loop or U-LT loop.