NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 100)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-58 Switching Commands
202-10010-01
config users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
readonly or readwrite . The <user> is the login user name for which the
specified access mode will apply.
Default readwrite for admin user; readonly for all other users
Format config users snmpv3 accessmode <user> <readonly/
readwrite>
show loginsession
This command displays current telnet and serial port connections to the switch.
Format show loginsession
ID Login Session ID.
User Name The name the user will use to login using the serial port or Telnet. A new user
may be added to the switch by entering a name in a blank entry. The user name
may be up to 8 characters, and is not case sensitive. Two users are included as
the factory default, admin and guest.
Connection From IP address of the telnet client machine or EIA-232 for the serial port connection.
Idle Time Time this session has been idle.
Session Time Total time this session has been connected.
config loginsession close
This command closes a telnet session.
Format config loginsession close <sessionID/all>
Security Commands
This section describes commands used for configuring security settings for login users and port
users.
This command permanently saves configuration changes to Non-Volatile Random Access
Memory (NVRAM).
Format save config