Show radius stats, Clear radius stats, Config dot1x adminmode – NETGEAR 7200 Series Layer 2 Managed Switch Software User Manual
Page 107: Config dot1x port initialize, Config dot1x port reauthenticate, Show radius stats -65, Clear radius stats -65, Config dot1x adminmode -65, Config dot1x port initialize -65, Config dot1x port reauthenticate -65
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands
7-65
202-10010-01
show radius stats
This command displays the RADIUS statistics that are not related to a specific server or to the
accounting server.
Format
show radius stats
Invalid Server Addresses
The number of RADIUS Access-Response packets received from unknown
addresses.
clear radius stats
This command clears all RADIUS statistics.
Format
clear radius stats
config dot1x adminmode
This command enables or disables authentication support on the switch. The default value is
disable. While disabled, the dot1x configuration is retained and can be changed, but it is not
activated.
Default
disable
Format
config dot1x adminmode <enable/disable>
config dot1x port initialize
This command begins the initialization sequence on the specified port. This command is only valid
if dot1x is enabled and the control mode for the specified port is ‘auto’.
Format
config dot1x port initialize <slot.port>
config dot1x port reauthenticate
This command begins the reauthentication sequence on the specified port. This command is only
valid if dot1x is enabled and the control mode for the specified port is ‘auto’.
Format
config dot1x port reauthenticate <slot.port>