Config port linktrap, Config port physicalmode, Config port lacpmode – NETGEAR 7200 Series Layer 2 Managed Switch Software User Manual
Page 68: Config port autoneg, Show lag, Config port linktrap -26, Config port physicalmode -26, Config port lacpmode -26, Config port autoneg -26, Show lag -26
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-26
Switching Commands
202-10010-01
config port linktrap
This command enables or disables link status traps by interface.
Note:
This command is valid only when the Link Up/Down Flag is enabled. See “config trapflags
linkmode” on page 21 for more information.
Format
config port linktrap < slot.port|all>
<enable|disable>
config port physicalmode
This command sets the speed and duplex setting for the interface.
Format
config port physicalmode <slot.port|all>
<100h|100f|10h|10f>
Acceptable values are:
100h
100BASE-T half-duplex
100f
100BASE-T full duplex
10h
10BASE-T half duplex
10f
100BASE-T full duplex
config port lacpmode
This command enables or disables Link Aggregation Control Protocol (LACP) on a port. The
possible values for <mode> are enable and disable. The default value is disable.
Format
config port lacpmode <slot.port/all> <enable/disable>
config port autoneg
This command enables or disables automatic negotiation on a port. The possible values for
<mode> are enable and disable. The default value is enable.
Format
config port autoneg <slot.port/all> <enable/disable>
show lag
This command displays an overview of all link aggregations (LAGs) on the switch.
Format
show lag <logical slot.port|all>