NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 81)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-39
202-10010-01
config igmpsnooping adminmode
This command enables or disables IGMP Snooping on the system. The default value is disable.
Format config igmpsnooping adminmode <enable/disable>
config igmpsnooping groupmembershipinterval
This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.
Default 260 seconds
Format config igmpsnooping groupmembershipinterval <1-3600>
config igmpsnooping maxresponse
This command sets the IGMP Maximum Response time on the system. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3600 seconds.
Default 10 seconds
Format config igmpsnooping maxresponse <1-3600>
config igmpsnooping mcrtrexpiretime
This command sets the Multicast Router Present Expiration time on the system. This is the amount
of time in seconds that a switch will wait for a query to be received on an interface before the
interface is removed from the list of interfaces with multicast routers attached. The range is 0 to
3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.
Default 0
Format config igmpsnooping mcrtrexpiretime <0-3600>