Clear dot1x port stats, Config authentication login create, Clear dot1x port stats -70 – NETGEAR 7200 Series Layer 2 Managed Switch Software User Manual
Page 112: Config authentication login create -70
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-70
Switching Commands
202-10010-01
EAPOL Frames Transmitted The number of EAPOL frames of any type that have been transmitted by this
authenticator.
EAPOL Start Frames
Received
The number of EAPOL start frames that have been received by this
authenticator.
EAPOL Logoff Frames
Received
The number of EAPOL logoff frames that have been received by this
authenticator.
Last EAPOL Frame Version The protocol version number carried in the most recently received EAPOL
frame.
Last EAPOL Frame Source The source MAC address carried in the most recently received EAPOL frame.
EAP Response/Id Frames
Received
The number of EAP response/identity frames that have been received by this
authenticator.
EAP Response Frames
Received
The number of valid EAP response frames (other than resp/id frames) that have
been received by this authenticator.
EAP Request/Id Frames
Transmitted
The number of EAP request/identity frames that have been transmitted by this
authenticator.
EAP Request Frames
Transmitted
The number of EAP request frames (other than request/identity frames) that
have been transmitted by this authenticator.
Invalid EAPOL Frames
Received
The number of EAPOL frames that have been received by this authenticator in
which the frame type is not recognized.
EAP Length Error Frames
Received
The number of EAPOL frames that have been received by this authenticator in
which the frame type is not recognized.
clear dot1x port stats
This command resets the dot1x statistics for the specified port or for all ports.
Format
clear dot1x port stats <slot.port/all>
config authentication login create
This command creates an authentication login list. The
<listname>
is up to 15 alphanumeric
characters and is not case sensitive. Up to 10 authentication login lists can be configured on the
switch. When a list is created, the authentication method “local” is set as the first method.
Authentication methods can be changed using the ‘config authentication login set’ command.