NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 22)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
3-2 Command Line Interface Syntax
202-10010-01
Command
The text in bold, non-italic font must be typed exactly as shown.
Parameters
Parameters are order dependent.
The text in bold italics should be replaced with a name or number. To use spaces as part of a name
parameter, enclose it in double quotes like this: "System Name with Spaces".
Parameters may be mandatory values, optional values, choices or a combination.
– <parameter>. The <> angle brackets indicate that a mandatory parameter must be entered
in place of the brackets and text inside them.
– [parameter]. The [] square brackets indicate that an optional parameter must be entered in
place of the brackets and text inside them.
– choice1|choice2. The | slash indicates that only one of the parameters should be entered.
Values
ipAddr This parameter is a valid IP address, made up of four decimal
bytes ranging from 0 to 255. The default for all IP parameters
consists of zeros and a one (that is, 0.0.0.1). The interface IP
address of 0.0.0.0 is invalid. In some cases, the IP address can
also be entered as a 32-bit number.
macAddr The MAC address format is six hexadecimal numbers separated
by colons, for example, 0:6:29:32:81:40.
areaid Area IDs may be entered in dotted-decimal notation (for example,
0.0.0.1). An area ID of 0.0.0.0 is reserved for the backbone. Area
IDs have the same form as IP addresses, but are distinct from IP
addresses. The IP network number of the subnetted network may
be used for the area ID.
routerid The value of <router id> must be entered in 4-digit dotted-
decimal notation (for example, 0.0.0.1). A router ID of 0.0.0.0 is
invalid.
slot.port This parameter denotes a valid slot number and a valid port
number. For example, 0.1 represents slot number 0 and port