NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 57)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-15
202-10010-01
Default enable
Format config network webmode <enable|disable>
config network javamode
This command specifies whether or not the switch should allow access to the Java applet in the
header frame of the Web interface. When access is enabled, the Java applet can be viewed from the
Web interface. When access is disabled, the user cannot view the Java applet.
Default enable
Format config network javamode <enable|disable>
config prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric
characters.
Default <model #>
Format config prompt <system prompt>
show serial
This command displays serial communication settings for the switch.
Format show serial
Serial Port Login Timeout
(minutes) Specifies the time, in minutes, of inactivity on a Serial port connection, after
which the Switch will close the connection. Any numeric value between 0 and
160 is allowed, the factory default is 5. A value of 0 disables the timeout.
Baud Rate The default baud rate at which the serial port will try to connect. This is selected
from a pull-down menu. The available values are 1200, 2400, 4800, 9600,
19200, 38400,57600, and 115200 baud. The factory Default is 9600 baud.
Character Size The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware Flow
Control is always disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is always 1.
Parity Type The Parity Method used on the Serial Port. The Parity Method is always None.