NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 76)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-34 Switching Commands
202-10010-01
config protocol protocol add
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group
may have more than one protocol associated with it. Each interface and protocol combination can
only be associated with one group. If adding a protocol to a group causes any conflicts with
interfaces currently associated with the group, this command will fail and the protocol will not be
added to the group. The possible values for protocol are
ip, arp, and ipx .
Default none
Format config protocol protocol add <groupid> <protocol>
config protocol protocol remove
This command removes the <protocol> from this protocol-based VLAN group that is identified
by this <groupid> . The possible values for protocol are ip, arp, and ipx .
Default none
Format config protocol protocol remove <groupid> <protocol>
config protocol vlan add
This command attaches a <vlan> to the protocol-based VLAN identified by <groupid>. A group
may only be associated with one VLAN at a time, however the VLAN association can be changed.
Default none
Format config protocol vlan add <groupid> <vlan>
config protocol vlan remove
This command removes the <vlan> from this protocol-based VLAN group that is identified by
this <groupid> .
Default none
Format config protocol vlan remove <groupid> <vlan>