NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 85)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-43
202-10010-01
config mirroring delete
This command removes the port mirroring designation from both the probe port and the mirrored
port and removes the probe port from all VLANs. The port must be manually re-added to any
desired VLANs.
Format config mirroring delete
config mirroring mode
This command configures the Port Mirroring mode. The possible values are enable and disable.
The default value is disable. The probe and mirrored ports must be configured before port
mirroring can be enabled. If enabled, the probe port will mirror all traffic received and transmitted
on the physical mirrored port. It is not necessary to disable port mirroring before modifying the
probe and mirrored ports.
Default disable
Format config mirroring mode <enable|disable>
show macfilter
This command displays the Static MAC Filtering information for all Static MAC Filters. If <all> is
selected, all the Static MAC Filters in the system are displayed. If a macaddr is entered, a vlan
must also be entered and the Static MAC Filter information will be displayed only for that MAC
address and VLAN.
Format show macfilter <macaddr vlan/all>
MAC Address The MAC Address of the static MAC filter entry.
VLAN ID The VLAN ID of the static MAC filter entry.
Source Port(s) Indicates the source port filter set's slot and port(s).
Destination Port(s) Indicates the destination port filter set's slot and port(s).
config macfilter create
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlan>. The <macaddr> parameter must be specified as a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6.
The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F,
01:80:C2:00:00:20 to 01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF.