NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 90)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-48 Switching Commands
202-10010-01
Port Up Time Since
Counters Last Cleared Time since port was reset, displayed in days, hours, minutes, and seconds.
STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent.
STP BPDUs Received Spanning Tree Protocol Bridge Protocol Data Units received.
RST BPDUs Transmitted Rapid Spanning Tree Protocol Bridge Protocol Data Units sent.
RST BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
MSTP BPDUs Transmitted Multiple Spanning Tree Protocol Bridge Protocol Data Units sent.
MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
config spanningtree port migrationcheck
This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is
the desired switch port. To set the migration check for all ports with a single command, "all" can
be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.
Default disable
Format config spanningtree port migrationcheck <slot.port/
all> <enable/disable>
config spanningtree port mode
This command sets the Administrative Switch Port State to a new value for the specified port. The
port <slot.port> is the desired switch port. To enable or disable all ports with a single command,
"all" can be specified. Note that only 4095 ports can be enabled.
Default disable
Format config spanningtree port mode <slot.port/all>
<enable/disable>
show spanningtree bridge
This command displays spanning tree settings for the bridge.
Format show spanningtree bridge
Bridge Priority Configured value.
Bridge Identifier
Bridge Max Age TConfigured value.
Bridge Hello Time Configured value.
Bridge Forward Delay Configured value.
Bridge Hold Time Minimum time between transmission of Configuration Bridge Protocol Data
Units (BPDUs).