NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 98)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-56 Switching Commands
202-10010-01
VLAN Identifier
Associated Instance Identifier for the associated multiple spanning tree instance or "CST" if
associated with the common and internal spanning tree.
User Account Management Commands
These commands manage user accounts.
show users
This command displays the configured user names and their settings. This command is only
available for users with readwrite privileges. The SNMPv3 fields will only be displayed if SNMP
is available on the system.
Format show users
User Name The name the user will use to login using the serial port, Telnet or Web. A new
user may be added to the switch by entering a name in a blank entry. The user
name may be up to 8 characters, and is not case sensitive. Two users are
included as the factory default, admin and guest.
Access Mode Shows whether the operator is able to change parameters on the switch(Read/
Write) or is only able to view them(Read Only). As a factory default, admin has
Read/Write access and guest has Read Only access. There can only be one Read/
Write user and up to 5 Read Only users.
SNMPv3AccessMode This field displays the SNMPv3 Access Mode. If the value is set to
ReadWrite,
the SNMPv3 user will be able to set and retrieve parameters on
the system. If the value is set to ReadOnly, the SNMPv3 user will only be
able to retrieve parameter information. The SNMPv3 access mode may be
different than the CLI and Web access mode.
SNMPv3Authentication This field displays the authentication protocol to be used for the specified login
user.
SNMPv3Encryption This field displays the encryption protocol to be used for the specified login
user.
config users add
This command adds a new user (account) if space permits. The account <name> is up to eight
alphanumeric characters. The <name> is not case-sensitive.
Six user names can be defined.
Format config users add <name>