NISSAN 2009 Quest - Manual (Page 148)

Using the interior lights
Push the button on the keyfob once to turn
on the interior lights and puddle lamps (if so
equipped).
For additional information, refer to “Lights on
demand switch” in the “Instruments and controls”
section earlier in this manual.
᭺
1 Pull the hood lock release handle located
below the driver’s side instrument panel. The
hood will spring up slightly.
᭺
2 Push the lever at the front of the hood to the
side as illustrated with your fingertips and
raise the hood.
᭺
3 Insert the support rod into the slot on the
underside of the hood.
When closing the hood, return the hood rod to its
original position. Lower the hood approximately
12 inch (30 cm) above the latch and release it.
This allows proper engagement of the hood latch.
WARNING
● Make sure the hood is completely
closed and latched before driving. Fail-
ure to do so could cause the hood to fly
open and result in an accident.
● If you see steam or smoke coming from
the engine compartment, to avoid injury
do not open the hood.
WPD0338
HOOD
3-14 Pre-driving checks and adjustments
੬
REVIEW COPY— 2009 Quest (van)
Owners Manual—USA_English (nna)
07/17/08—debbie
੭