How to use the setting button -5 – NISSAN 2009 Quest User Manual

Page 169

Advertising
background image

Tire pressure information

Pressure indication in **psi on the screen indi-
cates that the pressure is being measured. After
a few driving trips, the pressure for each tire will
be displayed randomly.

The order of the tire pressure figures displayed
on the screen does not correspond with the
actual order of the tire position.

Tire pressure rises and falls depending on the
heat caused by the vehicle’s operation and the
outside temperature.

In case of low tire pressure, a message “LOW
PRESSURE” or “CHECK ALL TIRES” is dis-
played on the screen:

LOW PRESSURE — CHECK ALL TIRES.

WARNING

When a spare tire is mounted or a wheel

is replaced, tire pressure will not be
indicated, the Tire Pressure Monitoring
System (TPMS) will not function and
the low tire pressure warning light will
flash for approximately 1 minute. The
light will remain on after 1 minute. Con-
tact your NISSAN dealer as soon as
possible for tire replacement and/or
system resetting.

Replacing tires with those not originally

specified by NISSAN could affect the
proper operation of the TPMS.

HOW TO USE THE SETTING
BUTTON

Pressing the SETTING button will change the
settings menu as follows:

Backlight

→ Day Mode Brightness → Night

Mode Brightness

→ Clock Adjust HOURS →

Clock Adjust MINUTES

→ Units → Lang → MP3

Disp Type (if so equipped)

→ Audio or OFF →

Backlight

Backlight

To turn off the screen, select “OFF” in the Back-
light mode by pressing the TUNE button.

The message “Press SETTINGS to resume” will
display for approximately 5 seconds then the
screen will turn off.

To turn on the screen, press the SETTING button
and select “ON” by pressing the TUNE button.

When any button besides SETTING is pressed
with the screen off, the screen turns on for further
operation. The screen will turn off automatically
after the operation is finished.

Day mode brightness

The brightness of the screen during the day can
be changed by pressing the TUNE button.

For additional information, see “

button”

later in this section.

Night mode brightness

The brightness of the screen during the night can
be changed by pressing the TUNE button.

LHA0620

Display screen, heater, air conditioner, audio and phone systems

4-5

REVIEW COPY—

2009 Quest (van)

Owners Manual—USA_English (nna)
07/17/08—debbie

Advertising