NISSAN 2009 Quest - Manual (Page 53)

5. For child restraints that are equipped with
webbing mounted attachments, remove any
additional slack from the anchor attach-
ments. Press downward and rearward firmly
in the center of the child restraint with your
knee to compress the vehicle seat cushion
and seatback while tightening the webbing
of the anchor attachments.
6. After attaching the child restraint, test it be-
fore you place the child in it. Push it from side
to side while holding the seat near the
LATCH attachment path. The child restraint
should not move more than 1 inch (25 mm),
from side to side. Try to tug it forward and
check to see if the belt holds the restraint in
place. If the restraint is not secure, tighten
the belt as necessary, or put the restraint in
another seat and test it again. You may need
to try a different child restraint. Not all child
restraints fit in all types of vehicles.
Rear-facing rigid-mounted – step 3
LRS0666
Rear-facing – step 5
LRS0673
Rear-facing – step 6
LRS0674
Safety—Seats, seat belts and supplemental restraint system 1-37
੬
REVIEW COPY— 2009 Quest (van)
Owners Manual—USA_English (nna)
07/17/08—debbie
੭